4D Paint | Painting | Paint Brush

Paint With Stencils

If you followed the last steps from Stamps then you should either Clear the Stamp or uncheck the "Use Stamp" checkbox.

Now do the following

1. Switch to the Stencil Tab
2. Drag and Drop an image into the "Image" field of the Stencil Tab
3. Position the Stencil over your model by holding down the T key and dragging the stencil around in the viewport.
   • Note: If the T key is not setup on your machine then you can set your own hot key by searching for "Sculpt Brush Stencil Adjust" in the command manager and assign your own override key for this feature. This key will override any other hotkey you have set up, but ONLY when you have a sculpt brush selected, such as the Paint Brush.
4. Start painting on the stencil to push the texture down onto your model.
5. If the texture is too light then make sure to change the Pressure Value up to 100%